How to install the seal strip with vhb 3m double sided tape?
1. The width of vhb 3m double sided tape is 2.5cm, and the width of the adhesive surface of the sealing strip is about 8mm. then Cut to 3 strips
2. Slowly glue the double-sided tape to the back of the sealing strip, glue it to one side first, then cut it off with scissors, glue the cut part to one side again, and glue the rest again, so as to make full use of the double-sided tape. If the car door side seam is large, and the welcome pedal is not a lot, it is recommended to put the door edge to do a seal, which should be able to reduce a little wind noise.
3. Clean the door edge and start sticking the sealing strip. First, stick a door sealing strip, use a little strength, and then slowly stick down the door side, uncover the protective paper of vhb 3m double sided tape, try to make the sealing strip stick neatly.The result is very good, much better than the effect of using the green adhesive
4. Next check the paste effect, the sealing strip can not be pulled off directly by hand, but it can only be torn off when it starts to tear from one side. The adhesive part of the double-sided tape and the car body is torn, and the other side is stuck on the sealing strip.There is no trace on the car body after removing the seal strip. If it is stuck in the wrong place, it can be easily redone, so it is recommended to use 3M double-sided tape.
5. Four doors were soon glued together.If it is found that there are gaps between the door and the car body after closing the door, the sealing strip along the car body is glued from front to back. After closing the door, the door is sealed tightly together with the door sealing strip, and the door does not feel that the door has become difficult.
6. A car is usually sealed with a 10-meter, 3M double-sided tape about 3 rolls.
This method of bonding sealing strip should be very good, not only to ensure the construction quality, but also stick wrong can be reworked, so I strongly recommend it to you.